The principle of the brush cleaning machine is to push the wire brush plate according to the driving force and gear transmission to remove the appendages on the working surface. According to the different configuration equipment and principles, it can be divided into heating type and touch type. There are three types: variant and round trip.

what to pay attention to when cleaning road markings? Heating-type brushing is used to heat the original markings before removing the markings, and then use the wire brush to remove them after the markings become soft; the thixotropic brushing is used to remove the markings before the cleaning is in progress. Brush the surface of the wire with a layer of organic chemical thixotropic paint remover to cause sufficient physical and chemical reactions such as touching, solubilizing, peeling, softening, separating, and falling off with the marking paint, and then use a wire brush The disc is cleared against the markings; the reciprocating brush cleaning is based on the working pressure of the elastic yellow in the wire brush disc according to the adjustment function, so that the wire brush disc is driven by the power system to the working surface to perform reciprocating fitness exercises, and then achieve the door The feng shui surface is not the same as the removal of marking paint or waste in deep gaps.

The scrubbing method can completely remove the marking paint, but because it must heat or solubilize the marking or have to go back and forth for fitness exercises, the removal rate is relatively slow. Therefore, it is not suitable for application under busy road traffic conditions. In addition, because of the noise during construction, it should not be applied under conditions where there are residents resting nearby.